F connector compression12/15/2023 Compression style F-Connectors are preferable to any other design.Once the cable has been prepared as above, you are ready for a RG6 F Connector.The more even and concentric you make it, the easier it will be to get an F connector onto the cable! F Connector Termination When combing back the second braid shield, it is important to comb it back as evenly as possible. Don’t leave any stray wires on the foil shield, it should all be combed back. You have to comb that back as well.Ĭombing back the second wire braid shield, exposing the final foil shield. Now the second wire braid shield is exposed. Do this carefully so that you remove all of the foil shield! Don’t leave any behind. No stray pieces of wire braid shield should remain against the foil shield!įind the edge of the 1st foil shield and fold it to the side so you can “nip” itĬarefully make a “nip” in the foil shield right at the bottom corner as shown.Make the comb-out as concentric and even as possible.Use the braid shield comb found on the tool to brush the first level wire braid shield backwards.The wire braid shield must be largely intact for the cable to function properly. If you see a lot of little pieces of wire braid accidentally cut off during this step, start over. You know you did well when pulling off the hollow jacket piece and little to no pieces of wire braid shield came off with it! Take the cable out of the tool and pull off the two pieces as below.After the grinding stops, continue turning three more times as this will now slice into the cable jacket for the second level strip.but be careful not to accidentally overstrip on this step, as you will remove more braid shield than you want to!.That is the first level strip blade cutting through the wire braid shields and down to the copper conductor. You will hear and feel a grinding noise.Once the cable is properly inserted, turn the entire tool clockwise. Put the cable end into the tool, cut-end even with the right side Fortunately, trueCABLE has been offering a handy tool for some time that does both of these functions and also has a braid comb on it, our Cable Cutting & Stripping Tool: The tools required for the job are one for cutting your cable to length and one for performing the correct strip. Combing back the second wire braid shield away from the second and final foil shield.Removing the first level foil shield to expose the second wire braid shield.Combing back the first wire braid shield away from the first foil shield.Stripping to 1/2”, with a 1/4” + 1/4” dual level strip involved.Quad shield coaxial cable is more challenging than dual shield when preparing the cable for termination. Commonality between all types being a cable jacket, dielectric, at least one wire braid shield, at least one foil tape shield, and 18 AWG conductor. The construction for the rest of the cable is the same as dual shield and tri shield varieties. Two shields are the aluminum wire braid shield and two more shields are aluminum foil. “Quad” literally means what it says there are four shields. RG6 quad shield coaxial cable is quite a bit thicker than dual shield.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |